MarkP Posted January 31, 2017 Share Posted January 31, 2017 Hi I have an Insteon system with about 35 devices. Most are dual band devices, but one switch had only 2 wires so I used the 2 wire RF switch. It has been working fine for a number of months, however recently I started to have issues. It is controlled by a motion sensor, and became intermittent in operation, and now does not respond to the motion sensor at all. It works fine locally (ie mechanically), and I can reliably control it directly from the ISY994i console, or from Mobilinc on my phone. When I do an ISY query on the switch, however, or try to restore it, I get a "Failed Communication With" message. Any suggestions would be appreciated. Thanks Mark Link to comment Share on other sites More sharing options...
paulbates Posted January 31, 2017 Share Posted January 31, 2017 Hi Mark Try factory resetting it, then repeat the steps for "Restore Device" Paul Link to comment Share on other sites More sharing options...
Techman Posted February 1, 2017 Share Posted February 1, 2017 Hi I have an Insteon system with about 35 devices. Most are dual band devices, but one switch had only 2 wires so I used the 2 wire RF switch. It has been working fine for a number of months, however recently I started to have issues. It is controlled by a motion sensor, and became intermittent in operation, and now does not respond to the motion sensor at all. It works fine locally (ie mechanically), and I can reliably control it directly from the ISY994i console, or from Mobilinc on my phone. When I do an ISY query on the switch, however, or try to restore it, I get a "Failed Communication With" message. Any suggestions would be appreciated. Thanks Mark What type of load is the switch controlling? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.