Aeotec Multisensor 6 Motion extremely slow to respond...

[JSylvia007]

Howdy all!  I have an Aeotec Multisensor 6 (on battery power), and I'm trying to use it to turn on my laundry room lights...  I figured this would be simple, but it's proving infuriating.

 

I have an Aeotec Siren as a repeater as well, but I'm not sure if it's being used in the communication chain.

 

I have created a simple program:

Laundry Room Motion - [ID 0024][Parent 0017]

If
        Status  'Inside House / Basement / Laundry Room / Motion Sensor / Laundry Room Motion Sensor' is On
 
Then
        Set 'Inside House / Basement / Laundry Room / Laundry Room' On
 
Else
   - No Actions - (To add one, press 'Action')

Now - It works, BUT, there is a 35 second lag time from the time that the green light comes on from the Aeotec until the lights actually turn on.

 

I tested this with my laptop, and from what I can tell, the program executes almost instantly on the ISY, so why does it take so long to trigger the Then??  Any help would be awesome.

[Techman]

It sounds like a communication problem. Put you ISY event viewer in level 3 mode then trigger the motion sensor.

 

Do you see any error messages in the viewer?

[JSylvia007]

It sounds like a communication problem. Put you ISY event viewer in level 3 mode then trigger the motion sensor.

 

Do you see any error messages in the viewer?

 

So... I tried removing the device and re-adding it... Same problem.

 

Then I held the action button down for 3 seconds to put the device in "awake" mode...  Had the ISY issue a Z-Wave HEAL and as soon as it finished everything worked perfectly.