Michaelv Posted May 8, 2009 Share Posted May 8, 2009 I have a power Monterey Instruments Power line signal analyzer I purchased in an attempt to locate and eliminate power line noise in my home. I used to have a fair amount of X-10 switches in my home but I have now swapped those out for an insteon network. I am still experiencing some “communication issues “ and I am being directed to try to locate the source of the noise. Can someone tell me what an acceptable level of noise is? Here is a random reading of the signal analyzer. I do not know if this is a lot of noise or a little noise. I can’t get anyone at Monterey instruments to pick up the phone. Here is what the Readings are. Noise: .5ms : 09m .2 to .9ms : 17m Thanks MV Link to comment Share on other sites More sharing options...
SteveL Posted May 9, 2009 Share Posted May 9, 2009 Sometimes the readings you get on an x-10 meter do not effect INSTEON performance, but it is a place to stare. What I look for is flashing on the access points. If i see a fast flickering when there is not INSTEON traffic than I use the access points to look for the source of the noise by turning off breakers at the panel and looking for the flickering to stop. Steve L Smarthome Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.