arzoo Posted November 29, 2019 Posted November 29, 2019 Hi All, I just added a new Motion Sensor II (to replace an older motion sensor). This is the first time I've used the new model and I've noticed when motion is detected it sends the ON command twice, and the same for the OFF command (30 seconds later). Is this normal behavior? I've tried changing the sensitivity but that makes no difference. The double signals are a problem for some of my programs. I guess I could add a wait statement but I'm just not sure if this is normal or the sensor is defective? Thu 11/28/2019 11:36:23 PM : [ 4F A0 20 1] DON 1 Thu 11/28/2019 11:36:23 PM : [ 4F A0 20 1] ST 255 (uom=100 prec=0) Thu 11/28/2019 11:36:23 PM : [ 4F A0 20 1] DON 1 Thu 11/28/2019 11:36:59 PM : [ 4F A0 20 1] DOF 1 Thu 11/28/2019 11:36:59 PM : [ 4F A0 20 1] ST 0 (uom=100 prec=0) Thu 11/28/2019 11:37:00 PM : [ 4F A0 20 1] DOF 1
Recommended Posts