gjadams Posted July 30, 2009 Posted July 30, 2009 I have a few of these appliance adapters that can turn on sensing a local load. ISY99 does not see the updates of the status. One is for a living room lamp and is used quite often. Any suggestions? Is this a supported feature or can I add this manually and make the system see this a different way?
Sub-Routine Posted July 30, 2009 Posted July 30, 2009 Hi gjadams, The older ApplianceLincs and LampLincs do not send any commands when controlled locally. The only way then to know the state is to Query the device at regular intervals. Rand
gjadams Posted July 31, 2009 Author Posted July 31, 2009 So, newer lincs will do this? Perhaps I might sell these on the well known internet auction site and get some new ones that do send the message. I'm able to write some logic, but I'd rather it be automatic. Can you confirm the model number and maybe even the rev of the appliancelinc and lamplinc? That would be great, but I appreciate the feedback either way!
MikeB Posted July 31, 2009 Posted July 31, 2009 As far as I know the ApplianceLinc does not support this feature, but LampLincs labeled v4.2 and higher (firmware v33+) do.
Recommended Posts