wjoel Posted March 21, 2020 Share Posted March 21, 2020 One of my insteon switches went on fritz, so I decided to replace a device. While adding it to device scenes, i continue to get the following error "could not open config file to read". I'm working in the Administrative Console. I'm baffled. ISY has been reliable. Link to comment
Brian H Posted March 21, 2020 Share Posted March 21, 2020 Did you add the new switch in the ISY994i and then use the replace with function to use the new switch where the older failed one was? Link to comment
wjoel Posted March 21, 2020 Author Share Posted March 21, 2020 The new switch was a relay and the old one was a dimmer, so the option was not available. Link to comment
Brian H Posted March 22, 2020 Share Posted March 22, 2020 Thanks for the clarification on not being the same or similar. I ran into this when I tried the new Dual Band On/Off modules for the older 2456S3 ApplianceLincs. Link to comment
Teken Posted March 22, 2020 Share Posted March 22, 2020 One of my insteon switches went on fritz, so I decided to replace a device. While adding it to device scenes, i continue to get the following error "could not open config file to read". I'm working in the Administrative Console. I'm baffled. ISY has been reliable. To be clear the bad device has been removed from the ISY Series Controller? Or did you simply (physically) pull it out? Sent from my iPhone using Tapatalk Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.