I have a ISY944I running 5.3.0 on both the firmware and the UI. I recently purchased 10 Aeotec repeaters in one final attempt to get my four Schlage locks to work with some degree of reliability. Using 8 of the Aeotec repeaters, it does seem like I have increased the reliability of the Z-wave locks. I wish we had some tool that would map out all the mesh nodes for the Z-wave and give signal strengths, link margins and bit error rates so I could smartly optimize the mesh network.... 

One thing still bothering me is the little green icon that apparently means I have updates to write to the devices never goes away. I try to write to the device by clicking the  "write changes" button, but it never changes the green icon. When I look in event viewer, there is some comms taking place, but I have no clue what it means. 

Any thoughts on this? 

Thanks

Wayne 

1 hour ago, wdhille said:

I have a ISY944I running 5.3.0 on both the firmware and the UI. I recently purchased 10 Aeotec repeaters in one final attempt to get my four Schlage locks to work with some degree of reliability. Using 8 of the Aeotec repeaters, it does seem like I have increased the reliability of the Z-wave locks. I wish we had some tool that would map out all the mesh nodes for the Z-wave and give signal strengths, link margins and bit error rates so I could smartly optimize the mesh network.... 

One thing still bothering me is the little green icon that apparently means I have updates to write to the devices never goes away. I try to write to the device by clicking the  "write changes" button, but it never changes the green icon. When I look in event viewer, there is some comms taking place, but I have no clue what it means. 

Any thoughts on this? 

Thanks

Wayne 

 

 

Take a look at this thread:

 Release 5.3.1 Test Build is now available - Current Release, Betas, and Bug Reports - Universal Devices Forum (universal-devices.com)