Oakland Jeff Posted June 19, 2021 Posted June 19, 2021 A few days ago my Motion Sensors all stopped triggering programs. I replaced batteries, but no joy. Today I dug a little deeper and noticed that the ISY Admin Console Event Viewer was not registering any coms with them. I rebooted the ISY and the PLM. Still no wireless coms. THEN I noticed that even events from my wired switches were not reflected in the Event Viewer (yep, level 3). Oddly, I'm still able to control all the lights from the Admin Console! For example: When I toggle a scene from the admin console, the event viewer shows a single TX line and a single ACK line. When I toggle a device, I get the following, which I think is normal? Fri 06/18/2021 09:52:46 PM : [INST-TX-I1 ] 02 62 1B B0 D6 0F 13 00 Fri 06/18/2021 09:52:46 PM : [INST-ACK ] 02 62 1B.B0.D6 0F 13 00 06 LTOFFRR(00) Fri 06/18/2021 09:52:46 PM : [INST-SRX ] 02 50 1B.B0.D6 44.CD.0D 2F 13 00 LTOFFRR(00) Fri 06/18/2021 09:52:46 PM : [Std-Direct Ack] 1B.B0.D6-->ISY/PLM Group=0, Max Hops=3, Hops Left=3 Fri 06/18/2021 09:52:46 PM : [D2D EVENT ] Event [1B B0 D6 1] [ST] [0] uom=100 prec=0 Fri 06/18/2021 09:52:46 PM : [ 1B B0 D6 1] ST 0 (uom=100 prec=0) But again, when I manually turn on/of a switch on the wall... I see no events. Lastly, I tried to look at the PLM Links table. It seemed to not show anything!!!! Both Device & ISY Link Tables seem to be present and in sync with each other. I would very much like to hear your insights and try any other debugging and/or resolution steps. The sooner the better... I'm leaving for the weekend and my cat sitter will be here. I like to know if the sitter is roaming around the house where they shouldn't be. Also, my outdoor motion sensor is critical to protecting my Prius catalytic converter. I foil an attempt at least once a month because of my automated lights which make it look like we're awake and moving from room to room overlooking the car. Cheers, Jeff
Recommended Posts