hchain Posted October 11, 2021 Posted October 11, 2021 One of my IO modules does not accept "Trigger Reverse" anymore. It suddenly lost this setting (a lot of power outages lately). When I check "Trigger Reverse," the system shows Busy for a while and the check mark remains on when finished. But when I click Querry, it's gone again. The module is working well but the light on the 8-button panels is now reverse. Anything I can try (beside buying a new one Thanks!
MrBill Posted October 11, 2021 Posted October 11, 2021 Did you try Factory Reset, then Restore Device from the ISY?
Brian H Posted October 11, 2021 Posted October 11, 2021 You may want to run the Event Viewer in Level 3. To see if the messages show anything. Since the I/OLinc is power line only. You may want to try in a different location and branch circuit as a test.
hchain Posted October 23, 2021 Author Posted October 23, 2021 Sorry it took me so long, Brian, I was travelling. Long story short, I could not make it work, so I replaced the unit completely. Thanks for your suggestions, I did appreciate them. RV
Recommended Posts