I'm using this 4-in-one Sensor VER 2.0 on the 994i, v 5.3.0. I see from the event log it is waking up every 10 minutes. The manual says it's supposed to be 12 hrs. I have no idea how it got reset or changed (assuming it was ever 12 hr), nor have I found out a way to change it. There is a node (or whatever you call it) called "Notify Sensor" which has some buttons and time setting options for wakeup interval, but those appear to not work. I've tried manually waking the sensor up to write the changes. Is there a parameter # that will change this? I am able to change the parameters, at least the one I tried ("parameter 5"). 

On the Zooz support site search for advanced settings. The settings vary by firmware version.

Thank you for the response Techman, I figured it out. The buttons and data entry for setting the Wakeup interval do work. 

There apparently is no "parameter #" to set this. I checked Zooz support site and even contacted them. 

The problem was not paying quite enough attention to the event log. I was experimenting by trying to set either 300 or 900 seconds, not realizing 600 is the minimum and 600 is the step size. So either of those just changed the 'command' to 600. Setting it to 1200 sec works, here is the log. 

Fri 10/29/2021 10:19:57 AM : [ZWAVE-WAKE     5] Assigning Wakeup Interval 1200 seconds when device wakes up
Fri 10/29/2021 10:19:57 AM : [ZWAVE-BATCH    5.000] Write Device Changes pending for ZW005_1
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Awake with pending work ZW005_1
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Awake with pending work ZW005_1
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Wakeup Default Interval 43200 seconds
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Wakeup Minimum Interval 600 seconds
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Wakeup Maximum Interval 604800 seconds
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Wakeup Interval Step 600 seconds
Fri 10/29/2021 10:23:30 AM : [ZWAVE-WAKEUP   5] Assigning Wakeup to 1, Interval 1200 seconds