Need help with Zooz Zen71 wall switch as a program trigger

[Wes Westhaver]

I just installed two Zooz Zen71 On/Off switches and introduced them to my ISY. My ISY can see them and control them but I can't seem to get a simple test program to respond to them as controllers. I've included the test program below. My program is looking for any of the paddles to be pressed and then beep my FanLinc. It's a useless program but I hoped it would at least let me see if the paddle presses could be used as a program trigger. So far no luck. Any idea what I'm doing wrong???

 

GBaRm-ExhaustFan-TimeOut - [ID 0021][Parent 0020]

If
        'Modules / Guest Suite / Bathroom / GBaRm-ExhaustFan' is switched On
     Or 'Modules / Guest Suite / Bathroom / GBaRm-ExhaustFanPaddleBtn1' is switched On
     Or 'Modules / Guest Suite / Bathroom / GBaRm-ExhaustFanPaddleBtn2' is switched On
     Or 'Modules / Guest Suite / Bathroom / GBaRm-Lights' is switched On
     Or 'Modules / Guest Suite / Bathroom / GBaRm-LightsPaddleBtn1' is switched On
     Or 'Modules / Guest Suite / Bathroom / GBaRm-LightsPaddleBtn2' is switched On
 
Then
        Set 'Modules / Guest Suite / Bedroom / GBdRm-CeilingFan' Beep
 
Else
   - No Actions - (To add one, press 'Action')

 

Edited April 15, 2022 by Wes Westhaver

[Wes Westhaver]

Update:

I was able to fix the problem by performing a factory reset on the ZEN71's and then moving them closer to my ISY and re-introducing them to the ISY. Once that process finished I was able to see On/Off messages being transmitted to the ISY and was able to use these messages to trigger a program. So everything is working fine now.