CManson Posted June 20, 2022 Author Posted June 20, 2022 5 hours ago, Panda88 said: It looks like the token does not work correctly - it could be the API has locked you out (go to www.tesla.com and try to log in) - if that is ok try to generate another refresh token. If not recreate your credentials You can also try to erase the REFRESH_TOKEN entry under config - both key and token and then restart node server - it should auto generate the entry again. I think I did change the code to handle a car with no name, but we are not even getting that far here. So, overnight, it just started working! Thank you!
Panda88 Posted June 20, 2022 Posted June 20, 2022 7 hours ago, CManson said: So, overnight, it just started working! Thank you!
NYCScot Posted June 20, 2022 Posted June 20, 2022 So, before it became unusable due to the authentication issues, using the PG2 node server "Tesla" I had configured programs to set the cabin temperature/defrost the vehicle depending on the outside temp. There was always a challenge in awakening the vehicle with enough time to receive the command however and it was rather hit and miss. @Panda88, how do you recommend configuring programs to get around this issue?
Panda88 Posted June 20, 2022 Posted June 20, 2022 (edited) 48 minutes ago, NYCScot said: So, before it became unusable due to the authentication issues, using the PG2 node server "Tesla" I had configured programs to set the cabin temperature/defrost the vehicle depending on the outside temp. There was always a challenge in awakening the vehicle with enough time to receive the command however and it was rather hit and miss. @Panda88, how do you recommend configuring programs to get around this issue? the code for wake does a loop until the API responds (but you will not see this from the ISY. I could possibly make the status or climate node return a ON/OFF (a control for the node in the ISY) so it will change state when car goes from sleep to awake) but it has not been done yet - let me think about it - I do not have a car my self to test on and I only know people say the response is fairly fast these days - 30 sec or less worst case Also - the long poll wakes the car if a sleep so this should be a worst case scenario - you could use heart beat (short poll) at half the long poll duration and then program after a delay on either On or Off for the heart beat - I believe the PG poll is synchronized initially so they should happen aligned Edited June 20, 2022 by Panda88
Recommended Posts