dbwarner5 Posted December 12, 2022 Posted December 12, 2022 @Jimbo.Automates Hi Jim. I have three outputs that run a garage remote. An on value is meant to simulate the press of one of the three buttons on the remote. I use programming to run this normally but am trying to set up favorites in UDMobile and found that when I press "on", (at the bottom), the elk output stays on infinitely. I would have expected it to only stay on for the set default value of 2 seconds. Am I missing something? See screen shot below. When I press the "turn on for" button in the middle it correctly only stays on for 2 seconds. But pressing the on at the bottom of the screen seems to ignore the 2 second setting as the default on seconds. thanks.
Jimbo.Automates Posted December 13, 2022 Posted December 13, 2022 Yes, you will have to use the "Turn on For" inside UDI Mobile. But, if everyone using the ELK would like that to be the default On action, I could be convinced to change it or make it an option.
dbwarner5 Posted December 13, 2022 Author Posted December 13, 2022 It seems to me this setting is intuitively like a light switch "on" setting: ramp rate + level. If I set a "default" on value and ramp rate for a light, whenever I turn that light on, that is how it responds. Would think this should act the same way. If I set a default on setting, in this case "seconds", then whenever I turn on that device, I would seem to think that's how it should behave. Just my opinion...thanks.
Jimbo.Automates Posted December 13, 2022 Posted December 13, 2022 Makes sense, hopefully others using ELK outputs can chime in with their opinion.Sent from my Pixel 6 Pro using Tapatalk
Recommended Posts