Query All Program doesn't seem to work like before.

Not sure when this happened, or if it is new.

I notice that when I restart AC, the Query All should query everything, however the status does not show correctly for these Zen71 switches and is blank. If I manually query a switch after it will query its stated eg. On/Off.

I have tried running the Query All manually after AC starts up but still does not query these switches.

Other Z-Wave switches query fine though eg. Jasco, Leviton, Zen32, even my Watercop. I noticed this when I ran UD Mobile and the states of these switches did not allow the button press to turn on/off until is queried.

I have looked at My LIghting sorted by Current State and all remaining devices that have no state are types of scene buttons and basic assoc etc. which don't normally query. Therefore seems unique to a few switches, particularly Zen71 switches.

EDIT: I noticed also though that a basement hallway switch using a Jasco had same issue but may not be as consistent.

I think the Query All program has something wrong with it in this update because it runs way to fast now compared to before where it took quite a while.

Edited February 4, 20232 yr by brians
update