IoX Release v5.6.0 (Polisy/eisy) - OUTDATED

Welcome to ZMatter Z-Wave+ Beta v5.6.0 !

Features

• Support for OpenADR 2.0a pull/push
• Insteon I3 Custom LED colors on Dual Outlet
• Specify Z-Wave device interview timeout value

Bug Fixes

• Insteon I3 Dial status not updated after turning dial
• Insteon Thermostat set time command not using local time
• Programs: Notify combo box using old values (cache not cleared)
• Admin Console no longer closes (eisy) when upgrading packages
• Minor bug fixes

Getting Started

• Make a backup of Polisy or eisy (Admin Console | File | Backup IoX )
• Launch the Admin Console, go to the Configuration tab, click on Update Packages. Warning, this might take a while depending on how current your OS is
• On eisy
  • If you are using INSTEON, make sure the PLM is connected
  • Restart the Admin Console and make sure you are on 5.6.0. You will be notified of what should be done next including a reboot 
• On Polisy
  • Once completed (4 beeps + 1), click on Admin Console | Polisy System | Reboot
  • If you are using INSTEON, make sure the PLM is connected
  • Power up your Polisy note that initial boot might take a much longer time than normal because udx might want to install missing packages to assist with migration (in the future)
  • Once boot up is complete, Launch Admin Console

Migrating to ZMatter Z-Wave+

• Here are the instructions for migrating your Z-Wave network from ISY-994 or Polisy/Eisy to ZMatter Z-Wave+
  •   https://wiki.universal-devices.com/index.php?title=Eisy:User_Guide#Migration

Here are the installation instructions for those of you with a ZMatter Z-Wave board (not USB dongle):

• ZMatter-Assembly- Instructions.pdf (universal-devices.com).
• Ensure that the antennas are connected in the proper location (Z-Wave = yellow band, on the left. Zigbee = red band, on the right)