Jump to content

IoX Release v5.6.0 (Polisy/eisy) - OUTDATED


Chris Jahn

Recommended Posts

Welcome to ZMatter Z-Wave+ Beta v5.6.0 !

Features

  • Support for OpenADR 2.0a pull/push
  • Insteon I3 Custom LED colors on Dual Outlet
  • Specify Z-Wave device interview timeout value

Bug Fixes

  • Insteon I3 Dial status not updated after turning dial
  • Insteon Thermostat set time command not using local time
  • Programs: Notify combo box using old values (cache not cleared)
  • Admin Console no longer closes (eisy) when upgrading packages
  • Minor bug fixes

Getting Started

  • Make a backup of Polisy or eisy (Admin Console | File | Backup IoX )
  • Launch the Admin Console, go to the Configuration tab, click on Update Packages. Warning, this might take a while depending on how current your OS is
  • On eisy
    • If you are using INSTEON, make sure the PLM is connected
    • Restart the Admin Console and make sure you are on 5.6.0. You will be notified of what should be done next including a reboot 
  • On Polisy
    • Once completed (4 beeps + 1), click on Admin Console | Polisy System | Reboot
    • If you are using INSTEON, make sure the PLM is connected
    • Power up your Polisy note that initial boot might take a much longer time than normal because udx might want to install missing packages to assist with migration (in the future)
    • Once boot up is complete, Launch Admin Console

Migrating to ZMatter Z-Wave+

Here are the installation instructions for those of you with a ZMatter Z-Wave board (not USB dongle):

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...