n8huntsman Posted September 8, 2023 Share Posted September 8, 2023 (edited) Since you can't toggle outputs in the ELK M1 directly, I tried to turn on Output 2 to test my siren. I made output 1 and 2 visible, refreshed topology in ISY and the zones appeared in the ELL module of ISY. However, when I turn output 2 on in ISY, the status updates to 'ON' but nothing happens. When I do this for Output 1, my indoor siren sounds. Only difference is Output 2 is set to voltage output in ELK because its a siren instead of a speaker. I was starting to think I had a wiring issue even though ELK wasnt reporting a a supervisory problem. Then I created a rule in ELK console directly to turn on Output 2 when I open a door, and it worked with no issues. What could be preventing ISY from turning on that output? Edited September 8, 2023 by n8huntsman Link to comment Share on other sites More sharing options...
Recommended Posts