dblee1950 Posted January 26 Posted January 26 I have installed the UD USB Dongle and am attempting to get the TriSensor up and running. On my AC, it shows ZY 002 V1 Alarm and ZY 002 Wake Up. Light on sensor shows it is included FWIW. How to I get light and temperature readings from this?
Techman Posted January 26 Posted January 26 You should also have a node for light and temperature in addition to Alarm and Wake. The status window in the admin console won't populate until the sensor sends data which could take a while depending on the sensor settings. What controller and firmware version are you running?
dblee1950 Posted January 26 Author Posted January 26 UPDATE: I removed it and reinstalled and now see the other nodes.
dblee1950 Posted January 26 Author Posted January 26 I'm getting temp and lux readings, but when I try to do a query I get request failed error. I get it on all the nodes. Is that just the way it works or is there a setting I need to make? thanks
Techman Posted January 26 Posted January 26 You can't query a battery operated device because the device goes into a sleep mode to preserve battery life and doesn't see the query. 1
EJones01 Posted February 15 Posted February 15 I have the same issue, I have a Tri sensor and a 6, both just show the Alarm and wake nodes. This used to work and add the sensors too. Any ideas?
Techman Posted February 15 Posted February 15 @EJones01 The solution is in this thread Help with Aeotec Trisensor Setup - ZMatter - Universal Devices Forum (universal-devices.com)
EJones01 Posted February 15 Posted February 15 5 minutes ago, Techman said: @EJones01 The solution is in this thread Help with Aeotec Trisensor Setup - ZMatter - Universal Devices Forum (universal-devices.com) I think you posted the wrong thread.....the link is this thread?
Techman Posted February 15 Posted February 15 Correct, the solution is in this thread, posted on January 26th.
EJones01 Posted February 15 Posted February 15 (edited) 3 minutes ago, Techman said: Correct, the solution is in this thread, posted on January 26th. I don't see a solution? If you are talking about removing and readding, that is not it for me. Why would I take the time to search for a solution, read through the thread and then post that its not working for me? FYI, I have used these sensors for years, I know them inside out, have reprogramed them, have them running off power supplies, understand how to wake etc. etc. Edited February 15 by EJones01
Techman Posted February 15 Posted February 15 Yes, that's what I was referring to. Have you tried excluding and then including the sensor. When including it keep it in close proximity to your controller. What controller, Zwave dongle and firmware are you running?
EJones01 Posted February 15 Posted February 15 Just now, Techman said: Yes, that's what I was referring to. Have you tried excluding and then including the sensor. When including it keep it in close proximity to your controller. What controller, Zwave dongle and firmware are you running? Policy, 5.8.0, internal board. It was also doing this with the previous software.
EJones01 Posted February 15 Posted February 15 (edited) OK...got it. I redid an interview and sucked the info out of it. Edit: this worked once...and never again. back to the drawing board..... Edit2: It seems to only work 1 in 10 times. but I have both my sensors added now Edited February 15 by EJones01
Recommended Posts