oskrypuch Posted March 5 Share Posted March 5 (edited) I need to update a working Polisy (v13.0), running 5.4.4 and PG3 (with three weather nodes), with a serial PLM, and a large complicated Insteon network. It also has a plug in USB ZWave Zooz Stick 700 running a small number of ZWave. There a number of challenges, as the BIOS does have to be reflashed to factory state, the UPDATE button has a good chance of bricking it. I'm wondering specifically about the Zooz card, and my ZWave (all 700) setup. Once the Polisy is reflashed and IOX restored, do I just plug that same Zooz USB stick back in, and it should just work? Or is the setup going to be all farkled, and I will have to start over? There is no backup available for the Zooz stick, but I'm wondering if it is needed, as all the definitions I believe reside on the stick itself. * Orest Edited March 16 by oskrypuch Link to comment Share on other sites More sharing options...
oskrypuch Posted March 16 Author Share Posted March 16 Anyone? I may be the last guy using one of these, I know! 😀 * Orest Link to comment Share on other sites More sharing options...
oskrypuch Posted March 16 Author Share Posted March 16 Given that I have only about 15 Z-Wave nodes, I may just bite the bullet, and grab a new Matter board, and do a complete manual rebuild. It seems the 700 stick -> Matter board migration process can be finicky. And, I can obviously carry the board forward once/when I move to an Eisy in the future. * Orest Link to comment Share on other sites More sharing options...
Recommended Posts