ThisIsTheWay Posted December 5, 2024 Posted December 5, 2024 I have the following setup M.BeDd-Overhead - scene - to drive both overhead can lights PBed Can 1 + PBed Can 2 PBedOverhead(dummy) - switch linc dimmer - load is capped as it is just a dummy switch- controls M.Bed-Overhead PBed Can 1 - micro dimmer module - driving a top hat can light PBed Can 2 - micro dimmer module - driving another top hat can light RL_Bed_Left-C-D - remotelinc as an 8 scene where buttons C/D controls M.Bed-Overhead RL_Bed_Right-E-F - remotelinc as an 8 scene where buttons E/F controls M.Bed-Overhead I setup a program that when PBed Can 2 is off and someone pressed off RL_Bed_Left-C-D, it should turn on only Can 2 (plan to do the same with RL_Bed_Right-E-F when it get it working on RL_Bed_Left-C-D) Whenever i press, RL_Bed_Left-C-D while PBed Can 2 is off, it does turn on only PBed Can 2 but after a second or two, PBed Can 2 turns off. I cannot figure out why...
Recommended Posts