thruster999 Posted July 30, 2010 Posted July 30, 2010 Hello I have ten 2420M motion sensors in my home serving 10 different rooms. All of them work when it comes to motion and all of them report their status, as On/OFF, in "Current State" on the ISY-99i's Main device list table. However Only 5 of them report the "Current State" as either On/Off for Dusk/Dawn. The remaining 5 report nothing (blank) and I can't use this status for programming. Is the ISY-99i limited to only being able to read 5 Dusk/Dawn sensors? btw the 5 that don't work are all located near an access point and near other sensors that work. All sensors have both jumpers 3 and 5 set to on. Thanks
Brian H Posted July 30, 2010 Posted July 30, 2010 Are they the same hardware and firmware revisions for the Motion Sensors?
TJF1960 Posted July 31, 2010 Posted July 31, 2010 If the motion sensors are the newer type with the trim pot adjustments then check the dusk/dawn settings thru the ISY. If the dusk/dawn is set for 0 the motion sensor will never send a d/d On. Tim
thruster999 Posted July 31, 2010 Author Posted July 31, 2010 Hi All of the Motion Sensors are Rev 2.0 Thru the ISY all of the Dusk/Dawn settings, including the one that are reporting an ON/OFF, are set to 102.
Recommended Posts