Hi All.

ANYONE out there with a Zooz ZSE70 able to view and use the Temperature data it is supposed to send? None of my nodes for it show Temperature but it is one of the main advertised features of this sensor and one that I want to use. ANY feedback appreciated.

I am currently on v5.8.4 on a Polisy but have an eISY for spare that I will eventually move to - I will move to it sooner if someone tells me that it will enable seeing & using Temperature from this sensor.

Thanks!

Shawn

I have an EISY with 6.0.5 firmware and the ZSE70 shows the temperature.

You should probably try updating your Polisy/Eisy firmware

3 hours ago, Techman said:

I have an EISY with 6.0.5 firmware and the ZSE70 shows the temperature.

You should probably try updating your Polisy/Eisy

Do you remember when you installed your ZSE70? Or, do you remember what level you were at when you installed it?

Thank you, but correct me if I'm wrong - the next version after mine (5.8.4) had a good chance of bricking your Polisy, right? (no prob for eSIY)

Also, I thought not long after that they stopped Polisy from getting new versions before the v6.0.0 arrived?

Thanks!

It's best to open a support ticket before you try to upgrade your Polisy . See the link below

Updated Software Available! - Current Release Announcements - Universal Devices Forum

You'll want to have the lastest firmware versions on your Polisy and EISY before you migrate from the Polisy to the EISY

Do you have the UDI Zwave/Matter board on both the Polisy and Te EISY?