Motion Sensor ver 2

[jkraus]

My "old" MS of 1.5 years died and so I ordered a replacement (apparently only 1 yr warranty) and I noticed on the web the instructions have changed for ver 2 in that the "time out" is controlled via pots. Does that mean I cannot program the timeout via the ISY. In the past I linked the ISY to the MS then could set the exact time out (within 30 sec increments I think) very convenient, but now I have to rely on inaccurate pots? It seems that with pots, it would be a trial and error to get the right time.

 

I know many of you only use only the "on" command and the let ISY take care of the time out, but I have the light controlled by MS as well as in a scene controlled via a keypad, and right now I use the condition "If receive off AND keypad is off, then turn off light" so I need the "off" function

 

Joe

[Brian H]

Jumper 5 installed allows you to do remote programming with software.

 

The updated users manual has details in it.

[jkraus]

Thanks much! Sorry for not reading far enough!

Joe

[LeeG]

Follow this link for details on using the new ISY Set Options available in 2.8.3 and above.

 

http://forum.universal-devices.com/viewtopic.php?t=5184

[jkraus]

Very cool! Thanks for the link! almost glad my last one died, looks like a significant improvement Do I need 2.8.3 to be able to do this?

[LeeG]

Yes, 2.8.3 or above. I recommend using 2.8.4. There was a change in 2.8.3 unrelated to the MS that has caused some problems which was corrected in 2.8.4.