JSP0511 Posted August 5, 2012 Share Posted August 5, 2012 I'm wondering how often the ISY checks for the status of the I/O Linc sensor. My garage setup is an I/O Linc for the garage door w/status sensor and a Switchlinc for the garage light. I am setting up a program for when the garage is open (status = Off) between certain hours, that the light goes on for 5 minutes (or possibly have the light go off when the status of the door is back to closed (status = On)). The issue I am running into is that when I open the garage, the ISY is not seeing the sensor's status change therefore the light does not come on. Only until I query the sensor, does it's status change triggering the program. When I then close the garage door, same thing. I have to query it to get an update. I've waited more than a few minutes for the ISY to update itself but it does not. Is there something I'm missing that allows the ISY to see the status change right away? Link to comment
LeeG Posted August 5, 2012 Share Posted August 5, 2012 The I/O Linc is an I2CS device which requires 3.2.6. That is, 3.2.6 must have been running when the I/O Linc was added to the ISY. If on 3.2.6 suggest running a Restore Device to rebuild the link database in the I/O Linc. Sensor State changes should be seen immediately by the ISY. If not either links records are missing or there is a comm problem with the I/O Linc location. Link to comment
JSP0511 Posted August 5, 2012 Author Share Posted August 5, 2012 Oh nice, restoring device seemed to work! I was on 3.2.6 when I installed the I/O Linc. Thank you! Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.