Can't Get Scene to Work

[tpolito]

I have over 50 Insteon devices installed with an ISY. I am no expert, but consider myself to at least know my way around the ISY. I have many scenes set up throughout my house that work fine.

 

However, I am running into an issue here. I'm sure it has been addressed before, but I can't find anything specifically. I just installed a new Keypad Controlling a load, a new dual-band lamplinc, a new dual-band switchlinc, and an older switchlinc in a room. I have the latest ISY firmware. I have set up different Keypad buttons to control the other switches and that works fine. I also set up a nighttime scene where I want each of the loads to turn on at different on levels, including one at on-level 0. All of my current scenes are all on or all of, but I haven't done any at varying on levels before. I set up the scene in the ISY. When I turn it on from the Admin Console on my computer, it works perfectly. However, when I press the keypad button locally, all of the loads come on at 100%. Its like the links are there, the on level parameters just didn't get written. Am I missing something obvious?

[tpolito]

Nevermind.

 

I was highlighting the scene name and changing the on levels. Once I selected the controller within the scene and changed the levels there, it worked. What are the parameters when the scene name is selected used for?

[LeeG]

The Scene name can be used in ISY Programs and the Scene can be turned On/Off with the Admin Console. The Controller is the ISY PLM. As was noted each Controller can establish a unique set of Responder values for On Level and Ramp Rate. The On Level and Ramp Rate values are stored in each Responder keyed to the Controller Insteon address.