Jump to content
View in the app

A better way to browse. Learn more.

Universal Devices Forum

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Slow Flashing LED and Dead (?) Lamplinc

Featured Replies

Posted

I have a 2456D3 Lamplinc which was working ok, until it was not. Now when plugged in the LED just flashes on about once a second. Trying factory reset does nothing, can't connect to it from anything, holding the set button turns off the LED, then when released the LED goes solid for a moment, then goes back to flashing once per second.

 

Anything else I can try?

Pull it apart and take a real close look at the board.

Most likely a electronics failure.

If you decide to take the cover off. Look at D3, 30 volt zener. A common part that burns up or gets the board hot enough to unsolder itself.

Most likely a electronics failure.

If you decide to take the cover off. Look at D3, 30 volt zener. A common part that burns up or gets the board hot enough to unsolder itself.

 

Is there part number for the little bugger a mouser or digkey? I have to replaced a thermister on a keypandlinc switch type and would not mind ordering another few of these just in case.

 

Alan

Guest
This topic is now closed to further replies.

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.