TUhl01

Implemented Notifications over the weekend and tested with UD Mobile and Pushover. Both are receiving messages with no problems. UD Mobile provides a notification on my iPhone at time of receipt. However, no notification occurs for the Pushover message. Just updated to 3.6.9 and still have the problem. Iox and PG3 are at the current release levels. A message generated from the Pushover website to the iPhone provides a notification.

Fixed - Deleted RING from AC, PG3 Dashboard and reinstalled. Rebooted the EISY. RING test shows SUCCESS now.

Just updated to 1.1.1. Test is resulting in FAILURE. This is the 1st time that I tested for a while. Have not had any active events trigger my programs. This may have been a problem since changing from the Beta version to Production.

I made my purchase from the non-production store last week. I just deleted that version and reinstalled from the production store. All is good except I am back on a trial. How do I bypass purchasing again to make permanent?

Where is "Update" found?

How do I update to 1.1.0? Still showing 1.0.4 Beta

Why is this not showing as an update in UD Mobile?

@GeddyWhat causes losing the connection to the UD Portal? I have the same problem occurring randomly.

I had an offline occur about the same time EDT. Did not save the offline message. I restarted the EISY by doing a power off and on due to not getting an immediate restart. Puzzled why it went offline.

Where is this located - "Discover Devices"?

@Goose66 - I just upgraded to the EISY over the weekend and converted my Polyglots to PG3x. The MyQ is only showing 1 node versus 3. I am using the Polyglot on m Polisy using PG3 with no problems. I tried reinstalling, restarting, powering down the EISY to try to resolve. Firmware is 5.5.9 and all the other Polyglots are functional using PG3x - 3.1.23.

I have been running ZMatter on my Polisy successfully for over a month now. I converted all my devices to Z-Wave months ago to eliminate future Insteon issues. An EISY is being delivered tomorrow along with an USB ZMatter enclosure. I will install the ZMatter board in the enclosure and test with the Polisy before installing on the EISY. From my research, I should just have to perform a backup of the Polisy and a restore from the backup to implement the EISY after powering up. I would appreciate comments from those that have done the same recently. Hopefully this will be a straightforward conversion. Firmware is 5.5.7 and Polyglot PG3 is 3.1.18.

Same here - All devices and routines running very well. I'm very pleased with my Polisy and ZMatter board since replacing the ZooZ Dongle at the beginning of the month.

Updated today from the Admin Console on my PC with no problem. Never used the UD Mobile for updates.

Has anyone successfully been able to get this remote migrated to ZMatter and working? Attachment "B" is the result of the migration. Attachment "C" is the result of the Update and Interview. All the migrated nodes were deleted except the wall controller. This node was the only node highlighted when running the Update and Interview sync option. Attachment "D" is the result of adding the remote to ZMatter where the nodes are completely different than the migrated. Just want to be able to turn a lamp on and off.

You don't mention how the switch gets shut off. Do you use code to shut the switch off or do it physically?

Have the same problem and cannot find the combination to change. Yesterday my time zone was set at -5 which is correct. This morning for the same lat and long it is -4.