TUhl01

Yolink has 1 that works with EISY. You need a Yolink hub and the Yolink PG3 Plugin. I am using the thermometer and 6 water sensors. All work great and have problems with developing programs to interface with the devices. Many other devices are also available.

Same here in NC at 4:38 PM

Thanks - Topic Closed

In the post, he was the person that asked for this.

The information is included in this thread. Look above.

Is this error going to be resolved. Have not heard anything since submitting the debug log.

Attached is the debug log and a clip of the error section for your review. debug.log

Will do tomorrow.

Believe so. The log shows polling. This error happens randomly.

Why am I getting this error?

Seems to be working. I did notice that the short poll was set at 3600 and long 600. These were the values when reinstalled and before as I recall. Please check if these are the values that are in the download plugin. Changed short to 900 and long to 1800. Not sure if this caused the problem or a NOAA issue.

Debug log attached. debug.log

When will iOS 1.1.47 be available? Still at 46.

The plugin is not receiving updates. Deleted and reinstalled. This plugin has been working correctly since installed in April. debug.log

I needed something to do, so I started testing the UD Mobile Geofence function. Very easy to setup and it is doing its thing. Upon exiting the zone, a variable GEO_SW is being set to 0, entering the zone to 1. Program GEO TEST MSG is being used to send a UD Mobil message with the state of the value. So far, very impressed. Will use to turn on my garage lights after sunset at some point. GEO TEST MSG - [ID 0050][Parent 004E] If $GEO_SW is 1 Then Set 'SERVER - NOTIFICATION / Notification Controller / UD Mobile' Send Message Content 42 Notification ID (ID=42) Else Set 'SERVER - NOTIFICATION / Notification Controller / UD Mobile' Send Message Content 42 Notification ID (ID=42)

My Remote Connection Access was set to NO. Reconfigured and all 3 parameters were YES. The Ring Test now shows SUCCESS. However, still not getting a motion event in my program. Also, restarted a few times.

Don't see how this topic is related.

I have restarted, deleted and reinstalled. Just tried a restart again and still have the problem. The "Test Ring" keeps generating Failure versus Success. Totally puzzled. Yesterday I added a 2nd Ring Chime. However, chimes are not included in the server node that could cause this.

I have a few programs that are triggered by a RING device motion action. As of this morning, motion is not being activated in IoX. Submitted a ticket. Has anyone else had this problem?

Only 1 battery requires a charge when low. Always just removed the low battery for recharge while 2nd continues to power device.

Can the 2nd battery life be added for the device?

All Good. Compliments to the UD organization.

The Zen17 will not work with MyQ or other smart openers.

Yes - Only open and close status actions are being used in IoX.

Don't have an answer to that question. Suggest going to the PG3 store to get any information for the node server and the creator.