bmercier

That's what I though. Thanks for the quick response! Benoit.

Hi, Is this a bad practice to play with the program enable/disable? Sometime, I would like the status event to be ignored. Instead of using variable, I was wondering if I can simply disable/re-enable programs like in the example below. Or if I should avoid it for some reason. Example: PROGRAM-1 If Control 'RC / Cuisine' is switched Fast On Then Wait 5 minutes Disable Program 'PROGRAM-2' Set 'RC / Cuisine' Off Enable Program 'PROGRAM-2' PROGRAM-2 If Status 'RC / Cuisine' is Off Then ... ... Actually, my concern is that if this setting gets written to nvram, then I probably want to avoid it as I don't want to keep writing to it. Thanks, Benoit.

I wanted to do the same thing, but due to city regulations, I can only water during odd days. Odd addressed can water during Odd days, and Even adresses during even days. So, if that can be useful to someone, here's what I did. This program runs daily: If Time is 12:02:00AM Then $iDayOfMonth += 1 $iDayOfMonth Init To $iDayOfMonth $iDayOfMonthDiv2 = $iDayOfMonth $iDayOfMonthDiv2 /= 2 $iDayOfMonthDiv2 *= 2 Run Program 'SetDoMOdd' (If) Else - No Actions - (To add one, press 'Action') If the day = day/2*2, then it's not an Odd day: If $iDayOfMonthDiv2 is $iDayOfMonth Then $sDoMOdd = 0 Else $sDoMOdd = 1 But we need to restart correctly at the beginning of each month. If Time is 12:01:00AM on 2011/09/01 Or Time is 12:01:00AM on 2011/10/01 Or Time is 12:01:00AM on 2011/11/01 Then $iDayOfMonth = 0 $iDayOfMonth Init To 0 Else - No Actions - (To add one, press 'Action') For now, this is not ideal as we need to hardcode the next few months, but that allowed me to get going for the fall. Perhaps eventually we will be able to extract the Day of the month in a variable, or set a schedule for every xth day of a month. Benoit.

Hi, Since pretty much day one (4-5 month ago), my ISY-99 just freezes after a few days operating. It needs to be reset once in a while. When it freezes: - HTTP does not respond - Telnet does not respond - No programs gets activated. - Does not responds to ELK lighting. - Ping DOES respond I don't have, at least initially, I did not have any sophisticated rules. All that I can think of is that integration with Elk was done almost day one. Perhaps it has something to do. I have upgrade firmware to 3.1.6, and still same issue. I don't have a UPS to plug it in, but I figure that if I can ping, it's not a power issue. What can it be? Thanks, Benoit