CopyRon

Thank you upgrade was to 5.8.4

Power supply

UD Mobil suggested updating my workplace Polisy from 5.80 to 5.84. Polisy will no longer connect. Have rebooted - changed power supply When rebooting all 3 lights light for a second or so then only left light stays light and later a single beep. Portal stills says 5.8.0 disconnected. Any thoughts??

Thank you!!

om my polisy 3rd light flashing won't connect power cycled multiple time no avail any help Thank you!!

trying to set up Kwickset Zwave lock with mini remote so on activates lock and off activates unlock. I got to on to lock but can't figure out how to make off unlock Thank you!

Ditto

But we can use 800 devices with the 700 controller?

Will the Zmatter support ZOOZ 800 or can we add the https://www.thesmartesthouse.com/collections/zooz/products/zooz-800-series-z-wave-long-range-usb-stick-zst39.

Light is not lit, ordered a new one

Could my PLM have failed?

Updated to 5.7 and lost communication to keypadlinc and miniremote. All efforts to restore have failed. Deleted keypad (8 button) and can not add back - insteon engine not found Some help please, this is at work where I depend on these lights. Also lost all communication with Google and can't get z-wave to work in a scene.

Deleted Morninglinc and rediscovered saving old links working fine

no joy power cycle sorry but don't know the protocol

This morning I updated to 5.6.4 from 5.62 and noticed my morninglinc door lock wouldn't respond from admin console, yet it works fine from mini remotes and even reports correct status. Probably time to upgrade door lock,but this has worked well for me from I beta tested the original units. Any thoughts???