blueman2

That is what I thought. Thanks for the great help!!!!

That explains it! Now another question. How bad is it to set up a daemon program to constantly query status of these devices as a way to keep them up to date? I assume this is not a good thing to do.

Lamplinc is 2856D2 (Icon) 2 pin v.38. It is Blue in the My Lighting tree. I will check the device communication log and post in a bit. Thanks

I am using several lamplincs. One of the nice features of these is that even when turned off via a controller, you can still turn the lamp on by just using the lamp switch. The lampliinc senses when you turn the lamp off then on again, and turns the lamplinc on. However, the lamplinc does not send a signal back to the ISY-99i saying it is now on. ISY shows it as off. Of course, I could constantly query the device, but that would waste a lot of cycles on the ISY, right? Is there a better way to ensure the ISY knows what the status of the lamplinc is? The reason I need this is that I want to have an LED on my keypadlinc light up if ANY interior light is on. Lamplincs that are turned on my switching the lamp itself are making this hard to do.

Thanks for the reply. I think I solved the issue. I turns out my 99i was linking to the wrong gateway address. For some reason it chose a gateway address of one of my WAPs. I manually set the IP, mask and gateway addresses, and it now is working as it should. Thanks!

I am a new user here. Just got my ISY 99i/IR yesterday and have been trying to set it up with a single device to learn how to use it. I have it connected to the 2413S using ethernet cable to port A. Power supplied to the ISY unit. ALso have a 2450 relay plugged in as a test unit. I was able to get the system to see the 2450 and control it (yea!). However, whenever I open up the Admin console, it goes into an infinite loop with a pop up box labeled "Linking" which says in the box "Please do not power off/unplug the system or make adjustments to the linked/attached devices". This box ran all night long and it still running, going from 0 to 100% again and again and again and again. Running the latest non-beta firmware (I think 3.1.15). Any guidance? I also did update to latest Java.