Jimbo.Automates

Thanks for confirming. Now I just wish autelis would get some devices in stock! Sent from my SAMSUNG-SGH-I337 using Tapatalk 4 Beta

jtara92101, Does it look like this: http://awesomescreenshot.com/0391hxq5c9 and if so, don't you see the Admin console selection? That's what I see when I access mine from outside my network. #6 Here shows how to bring up the console a few different ways. http://forum.universal-devices.com/viewtopic.php?f=25&t=11533 - Jim

I had the same issue with my rules that ran the notification inside the then section. Even manually executing the then did not send a notification. I "updated" the notification run in that command to exactly what it already was, then saved all programs and it started working again. I just recently added notifications and updated to the latest 4.0.5 release, but I can't remember what order they were done, but it could have been an issue with updating. - Jim

I realize this is an old post, but why do you need both iAqualink and the Autelis?

I finally received it and had time to hook it up. The only problem is that it only responds to on commands, which will both open and close the door. It took a while to figure out how to get it working. Finally got it working both on its own by pushing the the button on the iolink, and with a KPL. But, can't get mobilinc working properly, it seems to always send on/off, ignoring how the iolink is configured. Guess I'll post something in the end mobilinc forum now. Sent from my Nexus 7 using Tapatalk HD

Just in case anyone else has this issue, I emailed Genie and they responded with: If you are connecting a non-series III device to the unit it will need to be connected to the BWC using a dry contact kit part number 38013r. Please contact our office with any questions at 800-354-3643. Also, I found this post on how to connect it to the wall button: http://www.perceptiveautomation.com/use ... 64&p=57237 I've ordered the part because I'd rather not run the wire to the wall switch. - Jim

I was wondering about that, but there are 2 connections available on the unit one is "Wall Console" and the other is "Intelligent Wall Console" so I was hoping the first one would work, but it wouldn't. I'll try your suggestion. Thanks, - Jim

I have the Garage door kit installed, but I'm not able to get the IOLink to trigger the opener. In the manual it says: Wall consoles from other manufacturers may not work with openers of these serial number groups. Use only the wall console provided with this unit. Each wall console has three buttons. http://www.manualowl.com/m/Genie/PowerM ... 933?page=8 The wiring diagram seems pretty standard: http://www.manualowl.com/m/Genie/PowerM ... 33?page=20 Anyone have a clue why this would not work? Thanks, Jim

What causes this error in my event log? Sun 12/16/2012 11:11:35 AM : [FileOpen ] Open failed for [/CONF/FF0901.REC] ® Sun 12/16/2012 11:11:35 AM : DB: Cannot load /CONF/FF0901.REC Sun 12/16/2012 11:11:35 AM : [FileOpen ] Open failed for [/CONF/FF0902.REC] ® Sun 12/16/2012 11:11:35 AM : DB: Cannot load /CONF/FF0902.REC That address does not match any of my devices? Or is it from my 2 X10 devices? Thanks, Jim