gregoryx

Someone else posted similar... and got it to work again by downgrading ISY to 2.6.11 I think. But I have almost the same versions you do and it's working. I cleared all my lighting out of the Elk after upgrading as well, FWIW. ISY-99 ProIR v2.6.13 Elk M1G v3.3.2 / 5.1.8 M1XEP 1.1.4 / 1.2.14 Only difference I see is the M1XEP firmware.

That is not what I see in 2.6.13. If I press button B on a KPL (non-load button, just to be sure) that is not part of any scene or links at all (haven't figured out what to use ALL the buttons for yet) and I'm in the Adminsitrative Console on the device itself, the "Current State" changes from "Off" to "On" and back. As a separate question: why run a program for this? Why not just make the button PART of the scene by adding "Office KPL D" to "Scene Office - South Track Light"? Other than our (mutual and long ingrained) HomeSeer habits?

I know this won't be much help, but you asked: I am running 2.6.13 beta on a ProIR and it is working well with Elk M1G; I can control lighting - manually at the Elk panel or through automation rules; and the ISY interface can arm/disarm the panel and see it's valid status. Is that what you were wanting to know? What may be different is that I defaulted my ISY before and after updating the code, since this is a fresh install.

TRUE DAT. Still... they work some of the time... eventually... mostly... maybe...

Thanks for the reply, Michel. If I understand, I should be able to tap the DIM or BRIGHT key every couple of minutes and not have a problem? If it's that easy, I can handle that. FTR, it did finally "take" all those links; I haven't tried the next group up - 50-some links, I think - we'll see how that goes next.

My RemoteLinc is working now. Thank you, Michel, for suggesting the factory reset. One scene I'm enrolling it in has 24 devices (including KPL buttons) to control. It took four attempts for it to finish without a failure. It seems to be working now. Anything special I should know or be concerned about?

I think the factory reset did it! Yay! Thank you!

Good point... and a common theme regarding Insteon's inconsistency to program as expected.

Hmmm... okay... maybe it's working, then. It only takes a minute or so for the progress bar to go away and the solid light on the RL goes back to flashing. Does that mean it's done? If so, where is the device represented in the UDI console software? How do I link it to things in the software? Correct. Not showing in the device tree at all. It is Rev 0.92 if that matters. It's pretty clear that ISY is talking to it - and appears to finish doing so... but nothing shows in the tree.

That's how it seemed. Prolly should be in the "EUI Enhancements" then.

Hmmm... okay... maybe it's working, then. It only takes a minute or so for the progress bar to go away and the solid light on the RL goes back to flashing. Does that mean it's done? If so, where is the device represented in the UDI console software? How do I link it to things in the software?

Any easy and reliable way to make all controllers execute the same scene attributes? I've got some scenes that have five controllers and ten responders (or more of each) and I'd like to be able to set the "scene attributes" and have all controllers take them.

Sorry... the earlier post on RLs left me a bit confused still... should I be able to program it without changing to I1-only mode by re-doing the DIM-BRIGHT thing when the light goes out?