barrygordon Posted April 6, 2013 Share Posted April 6, 2013 I can not get the ISY 994i to recognise this unit. Is there something special I must do? Link to comment
barrygordon Posted April 6, 2013 Author Share Posted April 6, 2013 Solved. I did not realise that the set button had to be pressed to put it in linking mode before it would be seen by the ISY Link to comment
LeeG Posted April 6, 2013 Share Posted April 6, 2013 All battery powered RF only devices have the same requirement. Motion Sensor, On/Off Sensor (TriggerLinc), RemoteLinc, RemoteLinc2, 2441ZTH thermostat, all must be put into linking mode so that they stay awake for approx 4 minutes. Otherwise the device is asleep to save battery life and cannot respond to commands. Link to comment
barrygordon Posted April 6, 2013 Author Share Posted April 6, 2013 Once Understood, Makes sense Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.