eduardo_garcia Posted April 25, 2013 Posted April 25, 2013 Hello Im having problems to link a open/close module to ISY. ISY displays the message "unsuported device 14.1" Does isy supports the open/close micro module? regards Eduardo
Brian H Posted April 25, 2013 Posted April 25, 2013 It is listed in the drop down modules list in firmware 4.0.3; link management tab.. Cat and sub cat is 0E.01
LeeG Posted April 25, 2013 Posted April 25, 2013 According to 4.0.3 information support for 2444 micro module open/close was added at 4.0.3.
Teken Posted April 26, 2013 Posted April 26, 2013 Does the 4.03 support all versions of the device including our EU brothers models? Teken . . .
LeeG Posted April 26, 2013 Posted April 26, 2013 Only the US variant is listed. The other micro modules list three variants. Since only two variants are being sold to this point likely another variant to come later.
Brian H Posted April 26, 2013 Posted April 26, 2013 The sub cat IDs for the 2444-422 and 2444-522 are not in the drop down list of modules. Until there is a 100-240 volt, 50-60 cycle Serial PLM. You are not going to get a ISY controller to work anyway.
eduardo_garcia Posted May 1, 2013 Author Posted May 1, 2013 hello Thanks for the help.... The power supply on my area is 220V and I can use isy to manage my devices. The PLM is dual band, all comunication is done using rf. regards Eduardo
Recommended Posts
Archived
This topic is now archived and is closed to further replies.