barkster Posted August 30, 2013 Posted August 30, 2013 My powerlinc module went out and I ordered a new one and replaced it but my when I launch the admin interface it won't control any devices but doesn't throw any errors and when I go to PLM status it shows ok. You don't have to link the powerlinc's do you. I tried and it didn't do anything. I can't remember it's been so long since I installed the first one.
Xathros Posted August 30, 2013 Posted August 30, 2013 You need to make sure that the ISY is not powered when you replace the PLM. Plug the new PLM into power first. Start up the ISY then log in and select Restore Modem (PLM) from the menu. -Xathros
barkster Posted August 30, 2013 Author Posted August 30, 2013 I think that was what I needed. Thanks!
barkster Posted September 17, 2013 Author Posted September 17, 2013 Hey I got my replacement PLM back from smart home and was going to swap it out with my new one for some odd reason. Now when I do restore PLM it does nothing. If I go to diagnostic it says plm is connected but it won't restore? Any ideas?
LeeG Posted September 17, 2013 Posted September 17, 2013 Did you power off the ISY and the old PLM, plug in the new PLM, power up the ISY, then do a Restore Modem (PLM).
barkster Posted September 17, 2013 Author Posted September 17, 2013 yeah twice... I'll try it a third time
Recommended Posts