How to set KPL switch states

[salex319]

I control a light from two separate KPLs. I created a Scene to do this and when I turn the light on/off from either KPL the other KPL properly shows the light's current status. I also have a program that turns this light off under certain conditions but I haven't been able to figure out how to make the KPL keys properly reflect that the light has turned off. I can set the backlight level but can't set the key state. How do I set the key state off on both KPLs when I turn the light off in a program?

[whlatimer]

Just a thought: If you have the program turn the scene on or off rather than the device, would that solve the problem?

[LeeG]

Backlight does not apply. That affects the On level of ALL buttons on the KPL. Have the Program turn the Scene On/Off rather then the light itself. Turning an individual device On/Off does not affect the linked devices.

 

Set Scene 'xxxx' On or Off

[salex319]

I thought that's what I needed (Set scene) but didn't see it. Works great. Thanks!