Hey guys,

 

I have a failry simple Insteon setup so far and this will be my most 'complex' setup which I'm having some trouble with. I am using an ISY 994i with a 2475SDB and I/O Link 2450 for this circuit.

 

I am basically trying to control my pool pump and millivolt pool heater. I have the 2475SDB wired in to the pool pump and have that working no problem. What I am trying to do is have the I/O Link 2450 control my pool heater's fireman switch (basically an open/close, no voltage). How do I link these two devices so that in any circumstance, the pool heater must be shut off 20 minutes prior to the pool pump shutting down. I'm a little lost on how to begin.

 

My pump is 120V 20A if there was any question about that.

 

Thanks.

djmoor,

 

The basic concept of what you are trying to do seems to be something like this.

 

If: Control of "Choose your Control" is Off

 

Then: Turn off Heater I/O Linc

then wait 20 min

then turn off pool pump

 

Please email me at support@universal-devices.com if you need further assistance.