szymas Posted May 20, 2014 Posted May 20, 2014 I have a basement with 4 banks of lights. The lights are on separate Insteon 2477S due to load restrictions. Basically I have a 8KPL that I wan to do the following: 1. the main on/off to turn on/off all 4 2477S (basically a all on/off button for my whole basement) I created this as a scene and it worked great! 2. I want to also be able to turn on/off the 4 banks independently with 4 of the other buttons.. but when I troed to do this the ISY stated that the 2477S was already in a scene and to only make it a responder.. what am I doing wrong? Thanks!
Xathros Posted May 20, 2014 Posted May 20, 2014 Thats OK. A device can only be a controller of one scene but can be a responder to many. What you need to to do is: Remove the 2477S's from your first scene and add them back as Responders leaving only the KPL-A as controller. make 4 more scenes as follows: 1) KPL Button B as Controller and a 2477S as Controller. 2) KPL Button C as Controller and another 2477S as as Controller. 3) KPL Button D as Controller and another 2477S as as Controller. 4) KPL Button E as Controller and another 2477S as as Controller. In addition, you should add the KPL Buttons B,C,D and E to the first scene that you created as responders for the All On/Off scene. The ISY will tell you that these are all already controllers of another scene and allow you to add as responders. Hope that helps. -Xathros
Recommended Posts