Jump to content

New Elk water sensor not showing up in ISY


Envirogreen

Recommended Posts

Posted

Hi,

 

I have a water sensor which shows up as zone 38 in the Elk, but as you can see below - all other zones are here.  I have disabled, enabled, rebooted, reconfigured and no change.

 

Any suggestions?

 

1 1 Front Door Burglar Entry/Exit 1         1 2 Liv Win Right Burglar Perimeter Instant         1 3 Liv Win Left Burglar Perimeter Instant         1 4 Din Win Right Burglar Perimeter Instant         1 5 Din WIn Left Burglar Perimeter Instant         1 6 Kit Win Right Burglar Perimeter Instant         1 7 Kit Win Left Burglar Perimeter Instant         1 8 Fam Rm Win Burglar Perimeter Instant         1 9 Side Door Burglar Entry/Exit 1         1 10 L Bed Win Scr Burglar Perimeter Instant         1 11 Base Win Left Burglar Perimeter Instant         1 12 Patio Door Burglar Entry/Exit 1         1 13 MB Win Screen Burglar Perimeter Instant         1 14 R Bed Win Scrn Burglar Perimeter Instant         1 15 GB Liv Room Burglar Perimeter Instant         1 16 GB Din Room Burglar Perimeter Instant         1 17 2nd Flr Motion Burglar Interior         1 18 GB Fam Rm Burglar Perimeter Instant         1 19 Base Right GB Burglar Perimeter Instant         1 20 Base Left GB Burglar Perimeter Instant         1 21 Base Smoke Fire Alarm         1 22 CO2 Base Furn Carbon Monoxide         1 23 Rear Base Win R Burglar Perimeter Instant         1 24 Base Rear Win C Burglar Perimeter Instant         1 25 Kit Heat Fire Alarm         1 26 Co2 2nd Flr Carbon Monoxide         1 33 Laundry Burglar Perimeter Instant         1 34 Elec Window Burglar Perimeter Instant         1 35 Base Bath Win Burglar Perimeter Instant         1 36 Base Play Rm Win Burglar Perimeter Instant         1 37 Smoke 2nd Flr Fire Alarm         1 39 Side Window Scrn Burglar Perimeter Instant        

 

Posted

looks like there is an issue with the Elk

 

getting an error when I try logging in (Your control is busy or unavailable).

 

Need to get the guys that installed the Elk to address this, hopefully it fixes the ISY problem.

Posted

If you have ElkRP2 open, the ISY cannot connect. Make sure you have closed ElkRP2 on your computers, and then try 'Refresh Topology' again.

 

Michael.

Guest
This topic is now closed to further replies.

  • Recently Browsing

    • No registered users viewing this page.
  • Forum Statistics

    • Total Topics
      37k
    • Total Posts
      371.5k
×
×
  • Create New...