nowandthen Posted June 9, 2015 Posted June 9, 2015 (edited) This is for an 8 button KPL. I would like to define button G to be On and brighten when held down. I would like to define button H to be Off and dim when held down. I set button G and H to each be non-toggle. I put button G in a scene with the desk light. I clicked the red button under the scene name and set the on level of the light (listed on the lower half) to 30% and set a ramp rate. I put button H in a different scene with the desk light. I clicked on the red button G in the scene and set the light level to 0%. Button G works. Press and release and it goes to 30% as set in the scene. Press and hold, and it will brighten. (Locally the light goes to 60%, so I know the scene is controlling the level.) I cannot get button H to dim. It will only turn the light off, it will not dim. What am I doing wrong? The 6 button KPL comes with this ability out of the box, can we not make other buttons behave the same way? Thanks. The 6 button KPL comes with this ability out of the box, can we not make other button behave the same way? Edited June 9, 2015 by nowandthen
LeeG Posted June 9, 2015 Posted June 9, 2015 I assume H is set to non-toggle Off mode so it is not illuminated. In non-toggle Off mode the button generates an off command when pressed.
nowandthen Posted June 9, 2015 Author Posted June 9, 2015 (edited) It shows "Non-Toggle [On]" and it is not illuminated. I figured I would deal with illumination later. Edited June 9, 2015 by nowandthen
nowandthen Posted June 9, 2015 Author Posted June 9, 2015 (edited) Got it! I set button H to Non-Toggle [Off] mode, I didn't realize what it was asking when I went to set it to non-toggle mode. So with the button in Non-Toggle [Off] mode, I also had to change the lamp level to 100% (previously I had it at 0% and even in Non-toggle[Off] it would not dim.) Works great! Thanks Lee! You are amazing! Edited June 9, 2015 by nowandthen
Recommended Posts