I recently purchased 2 new garagedoor openers after a failure.  The new garagedoors were the chamberlain whisper drives with myQ.  I neglected to read up on the interface and it turns out, as I have noticed quite a bit on the forums that there is no way to communicate my IOLincs directly into the opener itself.  So.....

 

I looked around and found some information about them and wired my IOLinc directly into my opener remote.  I have put up a tutorial up here: http://www.agaveha.com/documentation/chamberlain-myq-bypass/

Thank you very much for the tutorial.

The tutorial will be a very big help to many users.

Make sure you read the following before you decide to do something like this.

 

http://www.cepro.com/article/potential_legal_liabilities_for_integrating_garage_doors_with_home_automati"]http://www.cepro.com/article/potential_legal_liabilities_for_integrating_garage_doors_with_home_automati

Edited July 12, 20169 yr by elvisimprsntr

I ended up doing the same thing but grabbed a Liftmaster 885LM control instead of using existing remote.  Works well, can usually find it under $20, and has some fairly easy solder points.

 

https://www.liftmaster.com/for-homes/Accessories/Control-Panels/model-885LM

I've done this same thing with 2 garage doors but used the lcd wall control that was provided with opener.

 

Sent from my SM-G920V using Tapatalk

I had the same problem with my two new Craftsman; I posted a video on YouTube doing exactly this with Insteon's hub, now on ISY - both work just fine... https://youtu.be/NBCdo0kANuM

 

It is an easy work around with these new multi-function wall remotes.