A few oddities after complete re do of ISY

[andrew77]

Hi guys;

 

I had my PLM go down and had to replace it. 

I've redone everything but I notice a few things are still hanging around from the original PLM/ISY programming.

 

With two SWLs, I press on (up) and they only go to a certain on level and stop.

I don't have them programmed to do this so I'm not sure how to make them stop.

 

Also When I press the B button on a KPL the A button comes on as well.

(I had this programmed like this before so this isn't much of a mystery except I thought by redoing everything this should have been erased.)

 

Any thoughts?

 

Drew

[larryllix]

SwitchLincs have a preset On level that you can program into the switch.

Either use dim to 100%, fast On, reprogram the level in the device page, or hold the SwitchLinc up button until the level is set to full On, but this could happen again later.

 

I have several of my SwitchLinc dimmers do this and I have installed programs to force them to 100% when they see an On control signal.

[andrew77]

Thank you Larry. Its been so long since I've had to tweak or fix anything as far as the ISY is concerned I've forgotten.

 

Still not quite up to 100% so I'm sure I'll be posting more questions over the course of the day.

 

Thanks again,

Drew

[larryllix]

The KPL LEDS are only controlled via scenes so you would have to find your scene and drag the B button out of it.