Jamison_IO Posted November 25, 2016 Share Posted November 25, 2016 I added an insteon motion sensor a few days ago and now when I make any changes (adding a different device to a scene) the controller acts like it is writing to that sensor - none of the changes i am making are related to it at all. It takes 2-3 times longer to run through all of the progress bars. It takes about two full minutes to add a switch to an existing scene with two other switches. Any ideas? Link to comment
stusviews Posted November 25, 2016 Share Posted November 25, 2016 Why do you suspect that the sensor is involved? Does the red LED on the MS light up when you make changes? Remove the battery from the MS (the ISY will report that it can't communicate with the MS, ignore that). Make some changes. Are the change faster? Link to comment
larryllix Posted November 25, 2016 Share Posted November 25, 2016 I added an insteon motion sensor a few days ago and now when I make any changes (adding a different device to a scene) the controller acts like it is writing to that sensor - none of the changes i am making are related to it at all. It takes 2-3 times longer to run through all of the progress bars. It takes about two full minutes to add a switch to an existing scene with two other switches. Any ideas? If your MS is included in the scenes you are modifying, ISY will attempt to be write to your MS, every change, inorder to change the link information. Link to comment
Jamison_IO Posted November 25, 2016 Author Share Posted November 25, 2016 Why do you suspect that the sensor is involved? Does the red LED on the MS light up when you make changes? Remove the battery from the MS (the ISY will report that it can't communicate with the MS, ignore that). Make some changes. Are the change faster? When it is writing the icons next to the sensor it says, "writing". If your MS is included in the scenes you are modifying, ISY will attempt to be write to your MS, every change, inorder to change the link information. No, that is the confusing part - the sensors are not in any scene at the moment. Here is a video of the screen - you can't see the progress bar or the selection of the scene, but that is happening in another window that wasn't captured. https://drive.google.com/file/d/0B95KWFwp3JXiMW5KcGZ0RnlKQkE/view?usp=sharing. Link to comment
G W Posted November 25, 2016 Share Posted November 25, 2016 You have unwritten data for the sensor. Either let the date be written to the sensor or turn off writing data to wireless devices. Link to comment
larryllix Posted November 25, 2016 Share Posted November 25, 2016 As per Gary, above. Put each MS into linking mode and let the writing complete, one MS at a time. Link to comment
Jamison_IO Posted November 27, 2016 Author Share Posted November 27, 2016 I think that was it. is there a way to take the MS out of linking mode or do i just have to wait? Link to comment
G W Posted November 27, 2016 Share Posted November 27, 2016 It will stop linking in about two minutes I'm Gary Funk. Pay no attention to this message. Link to comment
stusviews Posted November 27, 2016 Share Posted November 27, 2016 I think that was it. is there a way to take the MS out of linking mode or do i just have to wait? A single tap will take the MS out of linking (or unlinking) mode. Link to comment
larryllix Posted November 27, 2016 Share Posted November 27, 2016 Two taps gets the MS back to normal mode. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.