Multisensor 6 programs

[sumguy]

I am trying to create a program based on the temperature status of my Aeotec multi sensor 6. When I go to create a program, I only have a yes/no option where I should be able to select a temperature. There is an arrow pointing to the right just before the dropdown for where the temperature should be. When I select the arrow, it switches from yes/no option to one of my state variables. There are no other options.

 

I am on 5.0.4

 

The status of the sensors appear just fine when I select the multi sensor under devices.

 

Not sure if I am missing something simple or if others are having this issue.

 

Thanks in advance for any assistance.

 

Jason

 

 

[andyf0]

Well, for now, until 5.X is more stable you could put the temperature you're looking for into a variable.

[sumguy]

Thanks for the reply. I am not too familiar with variables. I only have set up geofence state variables. Can you provide me with a little more information on how I could set up the variable?

 

What I want to do is set up a program that turns off a fan that is plugged into an Insteon SwitchLinc when the room hits a certain temperature and turn back on if it goes above it.

 

I wanted to do a simple program - If status of master multi sensor temperature is less than or equal to 70 degrees,  then set master switch off, else set master switch on.

 

I have no idea how to set that with a variable. Wouldn't I need a program to update the variable state if a certain temperature is reached? Then I am back at the same issue. The program won't give me the option to set the temperature.

 

Any ideas would be greatly appreciated.

 

Thanks,

 

Jason