Peter.Cook Posted May 25, 2017 Posted May 25, 2017 I installed two TH8320ZW1000 thermostats but after putting the ISY994 in the Z-Wave add and include I get nothing. I tried to use the event viewer but don't see anything .I upgraded the z-wave firmware to 4.55/103 but not getting anything. Trying to figure out how to debug more. The ISY994 is about 40 feet away in the house..
andyf0 Posted May 26, 2017 Posted May 26, 2017 You do know you have to tell the thermostat to send it's Node information? It's in the thermostat settings, set RF to a value of "1" while the ISY is in Include mode.
Peter.Cook Posted May 28, 2017 Author Posted May 28, 2017 You do know you have to tell the thermostat to send it's Node information? It's in the thermostat settings, set RF to a value of "1" while the ISY is in Include mode. Thanks for the reply. It was doing that but apparently I had the ISY controller too far away. Moved it close and it hooked up. Solved by adding to AEOTEC Range Extender 6 devices. All now working.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.