rig doctor Posted June 23, 2017 Posted June 23, 2017 I recently installed the z wave dongle and software. The installation went very smooth and quickly added a couple of devices. That has been a couple of weeks ago. Today i added a GE switch with motion sensor. installation went fine. I later deleted the switch from the ISY and spent a while working on programming. I'm trying to add a few new devices and now under the z wave drop down box i get (z wave dongle not responding) Powered down the ISY and still no luck. Before i make matters worse trying to fix it i had better ask for advice. Help!
rig doctor Posted June 23, 2017 Author Posted June 23, 2017 In response to my own post. For those that it may help in the future. I unplugged power and took the dongle out, reset it into the main board and powered up again. Working properly at this time.
stusviews Posted June 23, 2017 Posted June 23, 2017 Did you delete the Z-Wave device as you would would delete any other device (wrong) or did you click on Z-Wave, Remove/Exclude a Z-Wave Device (correct)?
rig doctor Posted June 23, 2017 Author Posted June 23, 2017 It was actually a GE z wave hinge pin that i added. When i tried to remove/exclude it, the ISY would not pick it up. So i deleted it like i would have an Insteon device. I have added it again to see if it would work properly and it does not report changes in status. Now i can't get it to Remove/Exclude again. I suppose its just not supported? model zw6301 GE If I delete it like before will i have the same problem?
Recommended Posts
Archived
This topic is now archived and is closed to further replies.