Just added Z-Wave module .. question

[Jason Miller]

Hello, I just added the Z-wave module to my ISY994i. I'm an Insteon system, for the most part, but with a few items, I'm adding needed z-wave compatibility. I have no experience with Z-Wave devices, so excuse dumb questions:

1. I added the module inside the ISY device and added the software module, seems to be working

2. Must I add any "z-wave repeaters" or something to broadcast the signal?

I want to add: https://www.amazon.com/Aeotec-Multisensor-temperature-humidity-vibration/dp/B0151Z8ZQY/ref=cm_cr_arp_d_product_top?ie=UTF8

Will it work out of the box or do I need to do something as I mention in #2

[asbril]

Once the Zwave module has been properly added to your ISY there is no need to add a repeater, other than in special circumstances.

You should add your first Zwave device relatively close to the ISY, by selecting add/include from the Zwave button in your Administrative Console. Zwave works with a mesh structure and most (if not all)  non-battery powered Zwave devices repeat the signal of other Zwave devices. Therefore in principle the more Zwave devices you have the better your connection will be.

[stusviews]

Sometimes, a Z-wave device needs to Excluded before it can be Included.

[lilyoyo1]

Needing a repeater will depend on how close you are to your ISY and environment. Personally, I would get a repeater to be on the safe side rather assume one will not be needed.

[Jason Miller]

Found the device with no issues. Easy enough. Thanks for the input.

[Jason Miller]

All hooked up .. blogged about it at: https://jamz.net/schlage-connect-smart-lock-universal-devices-alexa/

Schlage connect smart lock, alexa unlocking and locking, on my ISY device.

So far, so good.