born2dive Posted August 21, 2018 Share Posted August 21, 2018 Is there a way to enable and disable ISY devices, remotely while I am away, using a program? Reading through the forum, I guess one way is to use variable and use it as a proxy for the device but that does not really disable the device. Any thoughts or examples would be appreciated. Thanks. Link to comment
rpsa Posted October 13, 2018 Share Posted October 13, 2018 I too would like that. I want to be able to disable some devives when I go away, but enable them just prior to my return home. Link to comment
larryllix Posted October 13, 2018 Share Posted October 13, 2018 The usual way most conclude in the end is. - Create a State variable called $sVacation. (note: I find vacation and away to be two different scenarios needed.) - Create ways to control the variable accurately when you are away from home. I use my $sAway variable with a 16 hour delay to automatically set the house into Vacation mode, as well as a few manual methods. - Use the variable to control key programs, disallowing them to run in the "If" section, or control Then / Else with a different routine based on $sVacation = $cTRUE or $cFALSE Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.