LarryM Posted October 7, 2018 Share Posted October 7, 2018 I have a 4-way light circuit. The 3 switches are linked to each other and all can turn the light ON/OFF. Indication of ON/OFF is seen on all 3 switches. I set up the "On Level [Applied Locally]" of Switch "A" (connected to the load) to 60%. I did the same for the other two switches. Only switch "A" goes to 60% when you single click the ON paddle. The other 2 switches go to full 100% even though their "On Level [Applied Locally]" are also set to 60%. Is there a way to get the other 2 switches to also go to 60% when you single click the ON paddles? Attached are the switch screens. Link to comment
lilyoyo1 Posted October 8, 2018 Share Posted October 8, 2018 Did you do it to the individual devices in the scene itself? Link to comment
LarryM Posted October 8, 2018 Author Share Posted October 8, 2018 Thank you for responding. You nailed it! That was the problem. These sliders were at 100%. After moving both to 60%, all switches now single tap to 60%. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.